Stratix Port SPAN / monitor - Wireshark
Content
This example shows how to set up a SPAN session (session 1) for monitoring source port traffic to a destination port. First, any existing SPAN configuration for session 1 is cleared and then bidirectional traffic is mirrored from source port 1 to destination port 10:
Switch(config)# no monitor session 1
Switch(config)# monitor session 1 source interface fastEthernet0/1
Switch(config)# monitor session 1 destination interface fastEthernet0/10 encapsulation dot1q
Switch(config)# end
This example shows how to configure the destination port for ingress traffic on VLAN 5 by using a security device that does not support 802.1q encapsulation:
Switch(config)# monitor session 1 destination interface Fa 0/5 ingress vlan 5
This example shows how to configure the destination port for ingress traffic on VLAN 5 by using a security device that supports 802.1q encapsulation:
Switch(config)# monitor session 1 destination interface Fa 0/5 encapsulation dot1q ingress vlan 5
This example shows how to disable ingress traffic forwarding on the destination port:
Switch(config)# monitor session 1 destination interface Fa 0/5 encapsulation dot1q
This example shows how to clear any existing RSPAN configuration for session 1, configure RSPAN session 1 to monitor multiple source interfaces, and configure the destination RSPAN VLAN and the reflector-port:
Switch(config)# no monitor session 1
Switch(config)# monitor session 1 source interface fastEthernet0/10 tx
Switch(config)# monitor session 1 source interface fastEthernet0/2 rx
Switch(config)# monitor session 1 source interface fastEthernet0/3 rx
Switch(config)# monitor session 1 source interface port-channel 102 rx
Switch(config)# monitor session 1 destination remote vlan 901 reflector-port fastEthernet0/1
Switch(config)# end
This example shows how to configure VLAN 901 as the source remote VLAN and port 5 as the destination interface:
Switch(config)# monitor session 1 source remote vlan 901
Switch(config)# monitor session 1 destination interface fastEthernet0/5
Switch(config)# end
REMOVE SPAN ONCES WIRESHARK IS COMPLETED:
Switch(config)# no monitor session 1
Switch(config)# end